BM4系列油壓馬達、行走液壓馬達

【簡單介紹】

產品名稱：產品型號：產品價格：200.00元/臺

【詳細說明】

BM4系列擺線液壓馬達

結構特點

采用鑲柱式定轉子設計，具有更高的配油精度及機械效率。

•雙滾動軸承設計,具有更大的側向承載能力。

•可靠的軸密封設計，承受背壓高，可以串并聯使用。

•正反轉換向方便、轉速平穩。

•多種油口、輸出軸、法蘭等連接形式。

Characteristic features：

•It adapts the gerolor design, which has a higher distribution accuracy and Mechanical efficiency.

•Double-rolling bearing design, which has a greater lateral load capacity.

•Credible design of shaft seal, which can bear higher pressure and be used in parallel or in series.

•Direction of shaft rotation and speed can be controlled easily and smoothly.

•A variety of connection types of flange; Rabbet:, output shaft and oil port.

1.zui大工作壓力指入口zui大壓力，額定壓力指工作壓差。

2.馬達不能同時在zui大壓力和zui高轉速下工作。

3.在斷續工作條件下，運行時間每分鐘不得超過10%。

4.*用68#抗磨液壓油，粘度37-73cSt,清潔度ISO18/13。

5.zui高工作油溫80°。

6.馬達全負荷工作前，應在zui高工作壓力的40%以下磨合1小時。

7.馬達允許zui高背壓10MPa，但建議不要超過5MPa，超過時應接外泄油管.

1. Intermittent means the entrance of the maximum pressure; continuous working pressure means the differential pressure

2. Motor should not work under the highest pressure and the maximum speed

3. The running time should not exceed 10% under intermittent working conditions

4. Recommending N68 anti-wear hydraulic oil, viscosity 37-73cSt, cleanliness ISO18/13.

5. The Maximum working temperature is 80 °

6. One hour running time under 40% of maximum working pressure is recommended before full capacity working.

7. The maximum allowable back pressure is 10MPa, but the recommended back pressure should not exceed 5MPa.a leaking pipes is needed when exceeding


留言框
感興趣的產品：	*
留言內容：
您的姓名：	*
您的單位：
聯系電話：	*
微信：
常用郵箱：
詳細地址：
省份：	*
驗證碼：	* = 請輸入計算結果（填寫阿拉伯數字），如：三加四=7
是否接受其他廠商報價:	* 匹配5家以內供應商匹配5~10家供應商匹配10家以上供應商不接受